Honda Odyssey Service Manual: Removal

Honda Odyssey Service Manual / Chassis / Suspension / Rear Spring/Bump Stop Removal/Installation / Removal

  1. Raise and support the vehicle.

  1. Remove the rear wheel.

  1. Position a floor jack under lower arm B. Raise the floor jack until the suspension begins to compress.

    2. BA14 x 1.5 mmReplace.

  2. Remove the flange bolt (A) from the knuckle.

  3. Lower the floor jack gradually.

  1. Remove the spring (A), the spring mounting cushion (B), and the lower spring seat (C).

    2. ABC

  1. Remove the bump stop (A) from the body if necessary.

    2. 10 x 1.25 mmA

    Exploded View

    Installation

    See More:

    Honda Odyssey Service Manual > Trunklid/Tailgate/Cargo Doors: Power Tailgate Drive Unit Replacement
    Remove the C-pillar trim. Remove the upper trim and the left tailgate side trim. Note the alignment marks on the drive unit and the arm unit, then carefully remove the two bolts (A), nut (B), and the arm unit (C). CB12 x 1.25 mm109.0 N·m (11.11 kgf·m, 80.41 lbf·ft)A2.2 N·m (2.2 kgf·m, 16.0 lbf ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0177