Honda Odyssey Service Manual: Driving Position Memory Switch Test/Replacement

Remove the driver's door panel.

Disconnect the 10P connector (A) from the driver's position memory switch (B).

Remove the two screws, then remove the switch from the door panel.

Check for continuity between the terminals in each switch position according to the table.

NOTE:

• Make sure the correct test lead (+ or -) is placed on the terminal.

• When checking for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.

• Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).

If the continuity is not as specified, replace the switch.

Install the part in the reverse order of removal.