Honda Odyssey Service Manual: Alternator Reassembly

  1. If you removed the OAD pulley, install it.

  1. Remove any grease or any oil from the slip rings.

  1. Put the rear housing assembly and the drive-end housing/rotor assembly together, tighten the four through bolts.

  1. Push the brushes (A) in, then insert a pin or drill bit (B) (about 1.6 mm (1/16 in) diameter) to hold them there.

  2. AB
  1. Install the brush holder assembly, and pull out the pin or drill bit.

  2. Install the end cover.

  3. After assembling the alternator, turn the pulley by hand to make sure the rotor turns smoothly and without noise.

  4. Install the alternator.

    Rotor Slip Ring Test

    Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation

    See More:

    Honda Odyssey Owners Manual > Bluetooth® HandsFreeLink®: HFL Menus
    The ignition switch must be in ACCESSORY or ON to use HFL. To use HFL, you must first pair your Bluetoothcompatible cell phone to the system while the vehicle is parked. ■Phone Setup ■ To pair a cell phone (when there is no phone paired to the system) 1. Press the PHONE button or the but ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.018