Honda Odyssey Service Manual: BSI OFF Switch Test/Removal/Installation

Honda Odyssey Service Manual / Chassis / Brake Control and Vehicle Dynamics / BSI OFF Switch Test/Removal/Installation

  1. Push out the BSI OFF switch (A) from the back of the dashboard, and disconnect the BSI OFF switch 6P connector (B).

    2. AB

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminal in each switch position according to the table.

    2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals
    TerminalPosition45PRESSEDRELEASED

  • If the switch does not work as described in the table, replace the switch.

  • If the switch tests OK, go to step 3.

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminals No. 1 and No. 2.   There should be continuity at all times.

    2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals?

  1. If the continuity is not as specified, remove the cover (A), and replace the bulb (B).

    2. BA

  1. Install the BSI OFF switch in the reverse order of removal.

    Installation

    Suspension Stroke Sensor Replacement

    See More:

    Honda Odyssey Service Manual > Ignition/Push Start and Steering Lock: Ignition Switch Replacement
    NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing. Do the battery terminal disconnection procedure. Remove the steering column covers. Disconnect the 5P connector (A) from the ignition switc ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0105