Install the damper/spring (A) on to the frame. Note the direction of the damper mounting base (B) as shown.
NOTE: Be careful not to damage the body.
Loosely install the new flange nuts (A) to the top of the damper.
NOTE:
Install the cowl top wiper cover (B) after tightening the flange nuts to the specified torque.
Different torque should be applied to the flange nuts when the
nuts are tightened with or without the damper mounting washer (C).
B A 10 x 1.25 mm without damper mounting washer type: 69 N·m (7.0 kgf·m, 51 lbf·ft) with damper mounting washer type: 59 N·m (6.0 kgf·m, 44 lbf·ft) Replace. C
Loosely install new damper pinch bolts (A) and new flange nuts (B) to the damper (C).
C B Replace. A 16 x 1.5 mm 175 N·m (17.8 kgf·m, 129 lbf·ft) Replace.
Connect the stabilizer link (A) to the damper (B), and loosely install the flange nut (C).
D E A C 12 x 1.25 mm 79 N·m (8.1 kgf·m, 58 lbf·ft) B
Tighten the flange nut to the specified torque, while holding the joint pin (D) with the hex wrench (E).
Tighten the flange nuts on top of the damper to the specified torque.
Tighten the damper pinch bolts while holding the flange nuts to the specified torque.
Install the brake hose bracket (A) to the damper (B).
8 x 1.25 mm 21 N·m (2.1 kgf·m, 15 lbf·ft) C D B A
Install the wire guide rubber (C) and the clip (D) to the damper.
Clean the mating surfaces between the brake disc and the inside of the wheel, then install the front wheel.
Check the wheel alignment, and adjust it if necessary.
