Honda Odyssey Service Manual: BSI OFF Switch Test/Removal/Installation

Honda Odyssey Service Manual / Body / Restraints / Restraints Control / BSI OFF Switch Test/Removal/Installation

  1. Push out the BSI OFF switch (A) from the back of the dashboard, and disconnect the BSI OFF switch 6P connector (B).

    2. AB

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminal in each switch position according to the table.

    2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals
    TerminalPosition45PRESSEDRELEASED

  • If the switch does not work as described in the table, replace the switch.

  • If the switch tests OK, go to step 3.

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminals No. 1 and No. 2.   There should be continuity at all times.

    2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals?

  1. If the continuity is not as specified, remove the cover (A), and replace the bulb (B).

    2. BA

  1. Install the BSI OFF switch in the reverse order of removal.

    BSI Control Unit Removal/Installation

    LaneWatch   System

    See More:

    Honda Odyssey Owners Manual > Audio System Basic Operation: Adjusting the Sound
    Press the SETUP button, and rotate  to adjust the setting. Rotate to scroll through the following choices: The SVC has four modes: OFF, LOW, MID, and HIGH. SVC adjusts the volume level based on the vehicle speed. As you go faster, audio volume increases. As you slow down, audio volume decrease ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.012