Honda Odyssey Service Manual: Special Tools Required

• KTC Trim Tool Set SOJATP2014

*Available through the Honda Tool and Equipment Program; call 888-424-6857

NOTE:

• If you remove the door upper molding, replace it with a new one because it will bend during removal.

• Put on gloves to protect your hands.

• Take care not to scratch the door.

• Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the screws, and detach the clip with a clip remover, then pull back the center seal (A).

2. Pull out the upper edge of the door upper molding (A) from the edge of the sash, and cut the double-sided adhesive tape (B) with a utility knife, then remove the molding from the sash.

3. Carefully remove the remaining double-sided adhesive tape from the sash, then clean the sash surface with a shop towel dampened with isopropyl alcohol.

4. Install the new door upper molding in the reverse order of removal, and note these items:

   • Push the adhesive areas into place securely.

   • Push the clip into place securely.