Honda Odyssey Service Manual: Tweeter

  1. From the notch (A), carefully pry the tweeter grille (B) out with a small screwdriver. Be careful not to damage the tweeter grille and the dashboard.

  2. CAB
  3. Disconnect the connector (C) from the tweeter.

  1. Remove the tweeter (A) from the tweeter grille (B).

  2. AB
  1. Measure the resistance between the tweeter (A) terminals as shown.

    • With navigation: Measure the resistance between the tweeter 2P connector terminals No. 1 and No. 2. There should be about 3.3 ?.

    • Without navigation: Measure the resistance between terminal No. 1 and the outside terminal of the capacitor (B). There should be about 4 ?. Also check the capacitor condition. If any problem is found, replace the tweeter.

  2. With navigation

    2 1 ?A

    Without navigation

    2 1 ?AB
  1. If the resistance is not as specified, replace the tweeter.


    Door Speaker

    Front Center Speaker

    See More:

    Honda Odyssey Service Manual > Data and Communication Network: BSI Control Unit Removal/Installation
    Remove the left rear side trim panel. Remove the BSI control unit (A). Disconnect the BSI control unit 16P connector (B) and detach the harness clip (C). Remove the bolt. BCA9.4 N·m(0.96 kgf·m,6.9 lbf·ft) Install the BSI control unit in the reverse order of removal. ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0102