NOTICE Do not operate the shift lever while pressing the accelerator pedal. You could damage the transmission. If the ignition switch is turned to ACCESSORY or LOCK while driving, the engine will shut down and all steering and brake power assist functions will stop, making it difficult to control the vehicle. Do not put the shift lever in , as you will lose engine braking (and acceleration) performance. During the first 600 miles (1,000 km) of operation, avoid sudden acceleration or full throttle operation so as to not damage the engine or powertrain. Avoid hard braking for the first 200 miles (300 km). You should also follow this when the brake pads are replaced. ■In Rain Avoid driving in deep water and on flooded roads. This can damage the engine or driveline, or cause electrical component failure. ■Other Precautions If there is a strong impact with something under the vehicle, stop in a safe location. Check the underside of the vehicle for damage or any fluid leaks. |
Honda Odyssey Service Manual > Front Knuckle/Hub Bearing Unit Replacement: Knuckle Replacement
Remove the hub bearing unit. Remove the wheel speed sensor (A) from the knuckle (B). Do not disconnect the wheel speed sensor connector. AB6 x 1.0 mm9.3 N·m (0.95 kgf·m, 6.9 lbf·ft) Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B). NOTE: During installation, inst ...