Seat belts are the single most effective safety device because they keep you connected to the vehicle so that you can take advantage of many built-in safety features. They also help keep you from being thrown against the inside of the vehicle, against other passengers, or out of the vehicle. When worn properly, seat belts also keep your body properly positioned in a crash so that you can take full advantage of the additional protection provided by the airbags.
In addition, seat belts help protect you in almost every type of crash,
including: ■ Lap/shoulder seat belts WARNING Be sure you and your passengers always wear seat belts and wear them properly. Seat belts cannot completely protect you in every crash. But in most cases, seat belts can reduce your risk of serious injury. Most states and all Canadian provinces and territories require you to wear seat belts. ■ Proper use of seat belts If a rear seat passenger moves around and extends the seat belt, the lockable retractor may activate. If this happens, release the retractor by unfastening the seat belt and allow the belt to retract completely. Then refasten the belt. Seat Belt Reminder Your vehicle monitors front seat belt use. If the ignition switch is turned to ON before the driver's seat belt is fastened, a beeper will sound and the indicator will blink. If the driver does not fasten the belt before the beeper stops, the indicator will remain on. The beeper will also periodically sound and the indicator will blink while driving until the driver's and front passenger’s seat belts are fastened. The indicator will also come on if a front passenger does not fasten their seat belt within 6 seconds after the ignition switch is turned to ON . When no one is sitting in the front passenger's seat, or a child or small adult is riding there, the indicator will not come on. This is because the weight sensors in the seat cannot detect their presence. Automatic Seat Belt Tensioners The front seats are equipped with automatic seat belt tensioners to enhance safety. The tensioners automatically tighten the front seat belts during a moderate-tosevere frontal collision, sometimes even if the collision is not severe enough to inflate the front airbags. The seat belt tensioners can only operate once. If a tensioner is activated, the SRS indicator will come on. Have a dealer replace the tensioner and thoroughly inspect the seat belt system as it may not offer protection in a subsequent crash. During a moderate-to-severe side impact, the tensioner on that side of the vehicle also activates. |
Honda Odyssey Service Manual > Crash Sensors: Side Impact Sensor (Third) Replacement
Removal Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work. Remove the rear side trim panel. Disconnect the side impact sensor (third) 4P connector (A) on the left or right side wire harness. Left side ABC Right side ABDC Remove the TORX bolt (B) using ...