The ignition switch does not turn from to . Why? ● The steering wheel may be locked. The ignition switch does not turn from to and I cannot remove the key. Why? The shift lever should be moved to . Why does the brake pedal pulsate slightly when applying the brakes? This can occur when the ABS activates, and does not indicate a problem. Apply firm, steady pressure on the brake pedal. Never pump the brake pedal. The rear door cannot be opened from inside the vehicle. Why? Check if the childproof lock is in the LOCK position. If so, open the rear door with the outside door handle. To cancel this function, push the lever to the UNLOCK position. Why do the doors lock after I unlocked the doors using a remote transmitter? If you do not open the doors within 30 seconds, the doors are relocked automatically for security. Why does the beeper sound when I open the driver's door? The beeper sounds when: Why does the beeper sound when I start driving? The beeper sounds when: Why do I hear a screeching sound when I apply the brake pedal? The brake pads may need to be replaced. Have your vehicle inspected by a dealer. California Proposition 65 Warning WARNING: This product contains or emits chemicals known to the state of California to cause cancer and birth defects or other reproductive harm. Event Data Recorders To read data recorded by an EDR, special equipment is required, and access to the vehicle or the EDR is needed. In addition to the vehicle manufacturer, other parties, such as law enforcement, that have the special equipment, can read the information if they have access to the vehicle or the EDR. The data belongs to the vehicle owner and may not be accessed by anyone else except as legally required or with the permission of the vehicle owner. Service Diagnostic Recorders California Perchlorate Contamination Prevention Act |
Honda Odyssey Owners Manual > Fastening a Seat Belt: Adjusting the Shoulder Anchor
The front seats and second row seats have adjustable shoulder anchors to accommodate taller and shorter occupants. 1. Move the anchor up and down while holding the release button. 2. Position the anchor so that the belt rests across the center of your chest and over your shoulder. The shoulder ancho ...